Depending on your homing selection before, this may or may not home the laser, and then should show Ready in the status box at the top of the laser tab, or the bottom status bar, depending on your system.If you are adding multiple devices, repeat the steps above for each machine. If your laser is connected to the computer, LightBurn will try to establish communication. Note: While the endstops are in in the back left, and the Homing Location is the back left, the Origin is not the same as Home. Choose the 0,0 origin point that matches your machine. Choose a distinct name and set your machine bed size for X and Y.Start with one for now, and add the others later. Don’t worry if you have more than one laser.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |